Our technical team can handle every aspect of your project: from project design and engineering, the production of P&IDs and 2D and 3D drawings, through to assembly, construction and workshop repairs, right up to the installation and refurbishment of systems on site.

Méca-Fluid is, above all, a provider of high-quality technical support

 

Project design and engineering

We approach your projects professionally, providing you with a high-quality service. Here are the various stages:

  • Submission of your idea
  • Our meeting (by telephone, online and/or in person)
  • Developing your idea
  • The importance and attention we attach to this stage to gather as much information as possible

These different stages will enable us to provide you with:

  • A thorough and bespoke analysis of your project
  • Our bespoke proposal
  • Further refinement or improvement based on your suggestions

This process applies, of course, to all projects and to any purchase, repair or replacement of a product (valve, cylinder, compressor, etc.) or the automation of a machine.

With regard to design and engineering, our team – comprising both junior and senior draughtsmen – will be able to produce P&ID diagrams, 3D pneumatic and/or electrical layout diagrams, 2D plans showing outputs, etc.

 

Technical Case 1

We were approached by a client in the heavy industry sector to resolve an issue with insufficient flow at the end of the line and poor compressed air quality. We therefore drew up the P&ID diagram of the installation in order to propose an effective solution to the client. To this end, we proposed the installation of a new compressor better suited to the system, an absorption dryer to improve air quality, and a flow meter to accurately measure compressed air and electricity consumption.

 

Technical case 2

2D drawings of pneumatic schematics and equipment layout for a pneumatic control cabinet used to operate control valves at a wastewater treatment plant

 

Contact us today to discuss your project

Design, construction and workshop repairs

Our technical team is constantly expanding in response to the growing number of requests for the construction of automated machinery, the fitting of pneumatic and electric actuators to valves (limit switch housings), control cabinets, control skids, dosing pumps, etc.

We also carry out repairs and overhauls of cylinders, pneumatic and hydraulic actuators, and compressors, as well as the replacement of sealing parts (seals, seats) on valves, and the replacement and calibration of electro-pneumatic positioners.

Technical case 3

Manufacture and installation of a pneumatic control cabinet comprising an isolation valve, an Asco FRL unit and a directional control valve used to control jib cranes comprising pneumatic cylinders for the heavy industry sector

Technical case 4

Installation of around a hundred electrically motorised butterfly valves to manage an entire water distribution network via a PLC in order to regulate flow

 

Contact us today to discuss your project

Installation and refurbishment of systems, machine revamping and on-site maintenance

Our on-site services are also clearly growing rapidly. Indeed, we are frequently called upon to replace and install compressed air systems – both partial and complete – to maintain compressors and to install pneumatic control cabinets.

Contact us now to discuss your project

Back to news